Owner`s manual

9. Turn the printer so the rear is facing you and remove
the two small screws (Figure 48, #1) from the
SheetFeeder connector bracket.
10. Remove the SheetFeeder connector and the metal
bracket that holds the connector in place.
Stepper
Motor
Right Side
Left Side
1
2
3
FIGURE 49
11. Turn the printer so the stepper motor is facing you and
remove the screw (Figure 49, #1) that holds the tractor
assembly to the metal frame.
12. Turn the printer to the right side and remove the screw
(Figure 49, #2) that holds the tractor assembly to the
frame.
13. Turn the printer so the rear is facing you. Hold the
round rod and plastic end pieces (Figure 49, #3) of the
tractor assembly and carefully pull straight toward you
until the tractor assembly is free from the frame.
Assemblies 1. Remove the mechanical assembly .
without
Screws 2. Remove the paper bail assembly .
ImageWriter II rev. Aug 91 Take-Apart / 2.61