Owner`s manual

1
FIGURE 47
8. On later models, lift up the front of the frame and pull it
toward you until it is completely out of the plastic
portion of the bottom cover. If the frame does not clear
the top rear of the bottom cover, push slightly at the
top of the back edge above each of the three molded
plastic frame holders (Figure 47, #1) of the bottom
cover.
Note: On earlier models, before you can remove the
frame from the plastic portion of the bottom cover, you
must disconnect the two cables mentioned in step 5
(the cables run along the right side of the frame and
disconnect at the right front of the printer).
ILLUSTRATION NOT AVAILABLE
FIGURE 48
2.60 / Take-Apart rev. Aug 91 ImageWriter II