Owner`s manual

o TRACTOR ASSEMBLY
Materials Required #2 Phillips screwdriver, magnetized
Small Phillips screwdriver, magnetized
Small flat-blade screwdriver
Remove Two versions of the tractor assembly exist: one version is
fastened in place with screws, the other version has a
snap-to-fit assembly (no screws). To remove the tractor
assembly, follow the directions below for the correct
assembly.
Assemblies with 1. Remove the paper cover and the tractor cover.
Screws
2. Remove the left and right support legs .
3. Remove the top cover.
4. Remove the bottom cover .
Note: The bottom cover procedure mentioned here
takes apart the rear metal portion of the bottom cover.
Sections of the bottom cover are shown on the
Illustrated Parts List. The plastic portion of the bottom
cover will be removed in step 8.
5. If you have a late-model printer, disconnect the cable
that goes from inside the right leg to the power switch
assembly (attached to the frame).
Note: If you have an early model, the cable runs from
inside the right leg along the right side of the frame
and is joined by the extension from another cable that
connects to the transformer. (Both of these cables on
earlier models disconnect at the right front of the
printer, and will be disconnected in step 8.)
6. Turn the printer upright. Carefully move the carrier
assembly slightly left of center to give access to the
two large screws (Figure 46, #1) that hold the frame to
the remainder of the plastic bottom cover. Remove the
screws.
2.58 / Take-Apart rev. Aug 91 ImageWriter II