Owner`s manual
Note
:
There is no paper-empty frame (Figure 36, #1)
when an optical paper-out sensor is installed.
LEFT SIDE
1
2
3
4
FIGURE 36
Replace
1.
Assemble the left side of the platen (Figure 36). Slide
the paper-empty frame (Figure 36, #1) into place and
insert the pin (Figure 36, #2). Slide the platen gear
and then the platen bushing into place (Figure 36, #3
and #4).
Note
:
There is no paper-empty frame (Figure 36, #1)
when an optical paper-out sensor is installed.
2.
Assemble the right side of the platen (Figure 37).
Slide the drive gear (Figure 37, #1) into position and
insert the pin (Figure 37, #2). Slide the platen spring
into position (Figure 37, #3).
RIGHT SIDE
1
2
3
FIGURE 37
2.48 / Take-Apart rev. Aug 87 ImageWriter II