Owner`s manual

10. Push the metal tab back toward the rear of the
machine (Figure 33, #4).
11. Verify that the impression lever is pushed forward all
the way. Position the clear plastic paper guide and
replace the two screws (Figure 33, #5). (Refer to
Section 4, Adjustments, if you need more information.)
12. Replace the carrier drive belt .
13. Replace the ribbon motor assembly .
14. Replace the color ribbon assembly .
15. Replace the ribbon wire and ribbon assembly .
16. Replace the mechanical assembl y.
17. Perform the self-test.
ImageWriter II rev. Aug 87 Take-Apart / 2.45