Owner`s manual

ILLUSTRATION NOT AVAILABLE

FIGURE 33

Place the carrier cam on the left side of the carrier

shaft. Be sure to position it as shown in Figure 33, #7,

with the smaller section as the top of the cam. The

wrong position will produce uneven printing.

IMPORTANT

: To be sure you get even printing

intensity, be sure to position the carrier cam with the

smaller section as the top of the cam.

Position the carrier assembly so the tabs underneath

the assembly (Figure 33, #1) are in place.

Push back the tab (Figure 33, #2), and slide the left

side of the carrier shaft into place while making sure

the right side is lined up.

Slide the right side of the carrier shaft into position,

making sure that the tab is in the hole in the metal

frame and that the impression lever is in position

(Figure 33, #3).

2.44 / Take-Apart rev. Aug 87 ImageWriter II