Owner`s manual

Replace 1. Slide the small three-pin connector, which is wired to
the print head PCB, onto the mount provided on the
carrier assembly (Figure 31, #5).
2. Position the print head PCB on the carrier assembly.
3. Replace the two screws (Figure 31, #3).
4. Position the bracket as shown in Figure 31, #1, and
snap it into place.
5. Slide the carrier shaft through one end of the carrier
assembly, replace the two felt wipers, and slide the
carrier shaft through the other side of the carrier
assembly (Figure 32, #1).
CARRIER ASSEMBLY
CARRIER SHAFT
1
FIGURE 32
ImageWriter II rev. Aug 87 Take-Apart / 2.43