Owner`s manual

6. Remove the two screws holding the clear plastic
paper guide (Figure 29, #1).
7. Look at Figure 29, #2, for the connection of the right
side of the carrier shaft to the frame. Pry forward the
metal tab that is part of the frame.
8. Gently insert a jeweler's flathead screwdriver into the
hole in the frame containing the tab
(Figure 29, #3). Gently push the tab backward and lift
the right side of the carrier shaft free.
9. Look at Figure 29, #4, to see where to connect the left
side of the carrier shaft to the frame.
10. Gently push back the metal tab (Figure 29, #5), and
slide the carrier shaft to the right until it is free.
11. Pull the back of the carrier assembly (Figure 29, #6)
toward the front of the machine to release the tabs
holding the assembly in position, and lift up the carrier
assembly and the carrier shaft.
12. Remove the carrier cam (shaped like a washer) from
the left side of the carrier shaft.
13. Turn the carrier assembly and the carrier shaft over.
Slide the carrier shaft free of the carrier assembly.
There are two felt wipers (for lubrication purposes)
where the carrier shaft slides through the carrier
assembly. Remove them (Figure 30, #1).
CARRIER ASSEMBLY
CARRIER SHAFT
1
FIGURE 30
ImageWriter II rev. Aug 87 Take-Apart / 2.41