Owner`s manual

Replace 1. Position the carrier motor with the connector and wires
toward the rear of the machine, and replace the three
screws (Figure 28, #4).
2. Replace the carrier belt on the left pulley and align it
(Figure 28, #3). Push in on the metal plate of the
carrier adjustment (Figure 28, #2), and replace the
carrier belt on the right pulley.
3. Place the plastic carrier belt guide in position and
replace the screw (Figure 28, #1).
4. Tighten the carrier belt adjustment screw.
5. Replace the ribbon assembly .
6. Replace the mechanical assembly .
7. Perform the self-test.
ImageWriter II rev. Aug 87 Take-Apart / 2.39