Owner`s manual

o CARRIER MOTOR AND CARRIER BELT
Materials Required #2 Phillips screwdriver
Remove 1. Remove the mechanical assembly .
2. Remove the ribbon plate . (It is not necessary to
remove the entire ribbon wire assembly.)
3. Remove the screw that holds the black plastic carrier
belt guide (Figure 28, #1). Some guides are glued to
the belt: Do not pry the guide off the assembly unless
you are replacing the carrier belt.
4. Loosen the carrier belt adjustment screw
(Figure 28, #2).
5. Gently push in on the metal plate under the screw,
and remove the drive belt from the right carrier motor
pulley. Lift the carrier belt from the machine (Figure
28, #3).
6. Disconnect the three screws holding the carrier motor
in place (Figure 28, #4). The motor will drop out.
2
3
1
4
FIGURE 28
2.38 / Take-Apart rev. Aug 87 ImageWriter II