Owner`s manual

9. Lift the right side of the mechanical assembly, and
disconnect the two plug connectors (Figure 25, #2).
10. Lift the entire mechanical assembly from the plastic
case.
Replace 1. Position the 50-pin cable on the bottom of the plastic
case. Place the noise filter PCB in the right support
leg. Verify that the PCB is lying flat in the bottom of the
leg.
2. Tilt the mechanical assembly into the plastic case.
Keep the right side lifted and connect the two plug
connectors (Figure 25, #2). Make sure the assembly
sits under the three white plastic tabs on the rear of
the case. Make sure all wires and cables are routed
correctly. Check for any crimped wires or cables.
Slide the mechanical assembly into the plastic case.
Line up the screw holders.
IMPORTANT: On new models of the printer, the plug
connector is located in the right support leg. Be sure you
connect the top two cables from the power-on switch to
the noise PCB and the bottom two cables to the
transformer. Failure to make these connections will
cause all lights on the operation panel to remain lit.
3. Replace the two screws (Figure 25, #1).
4. Replace the bottom cover.
5. Replace the left and right legs.
6. Replace the logic board.
7. Replace the top cover.
8. Replace the print head.
9. Replace the tractor cover.
10. Replace the paper cover.
2.36 / Take-Apart rev. Aug 87 ImageWriter II