Owner`s manual

o DRIVE PCB
Material Required #2 Phillips screwdriver
Remove 1. Remove the bottom cover.
2. Disconnect the cable from the transformer
(Figure 24, #1).
3. Remove the three screws from the drive PCB (Figure
24, #2).
4. Lift out the drive PCB.
DRIVE PCB
TRANSFORMER
1
2
FIGURE 24
Replace 1. Place the drive PCB on the bottom cover so the screw
holes line up.
2. Replace the three screws (Figure 24, #2).
3. Connect the cable from the transformer
(Figure 24, #1).
4. Replace the bottom cover.
5. Perform the self-test.
2. 34 / Take-Apart rev. Aug 87 ImageWriter II