Owner`s manual

o TRANSFORMER
Materials Required #2 Phillips screwdriver
Remove 1. Remove the bottom cover.
2. Disconnect the cable to the drive PCB (Figure 23, #1).
3. Remove the three screws (Figure 23, #2).
4. Lift out the transformer.
DRIVE PCB
TRANSFORMER
1
2
FIGURE 23
Replace 1. Place the transformer on the bottom cover so that the
screw holes line up.
2. Replace the three screws (Figure 23, #2).
3. Connect the cable to the drive PCB (Figure 23, #1).
4. Replace the bottom cover.
5. Perform the self-test.
ImageWriter II rev. Aug 87 Take-Apart / 2.33