Owner`s manual

6. Connect the three cables on the left side
(Figure 19, #3). There are two ways to connect the
three cables:
a) Some cables are long enough to allow you to lift
the left side of the access cover about 3 inches—
until you can reach the three connectors located
on that side of the board and connect them.
b) Using a pair of curved needlenose pliers, access
the three connectors through the left support leg,
and then gently connect them with the pliers.
1
FIGURE 20
7. Replace the four screws that hold the bottom cover in
place (Figure 20, #1).
8. Turn the printer right side up.
9. Connect the grounding connector to the spade on the
corner of the drive PCB (Figure 19, #1).
2. 30 / Take-Apart rev. Aug 87 ImageWriter II