Owner`s manual

11. Carefully lift the bottom cover from the back and flip
the bottom cover toward the front.
12. Disconnect the plug cable running from the right leg to
the transformer on the bottom cover (Figure 19, #2).
13. Remove the bottom cover.
DRIVE PCB
TRANS-
FORMER
2
1
3
4
FIGURE 19
Replace 1. Place the bottom cover face up on the bottom of the
printer.
2. Connect the plug cable running from the right leg to
the bottom cover (Figure 19, #2).
3. Lift the rear portion of the bottom cover, and connect
the 50-pin ribbon cable (Figure 19, #4).
4. Route the grounding strap from the transformer into
the right support leg.
5. Tilt the bottom cover toward you and lower it into
place. Check all the wires and cables: be sure they
are not crimped and are correctly routed.
ImageWriter II rev. Aug 87 Take-Apart / 2.29