Owner`s manual

o LEFT SUPPORT LEG
Materials Required #2 Phillips screwdriver, magnetized
Remove 1. Remove the paper cover.
2. Turn the machine upside down.
1
UNDERSIDE
OF LEFT LEG
LEFT LEG
FIGURE 14
3. Remove the Phillips screw at the base of the left leg
(Figure 14, #1).
4. Turn the machine right side up.
5. The interface cable connector slides in and out of two
notches on the inside of the leg. Push down on the
leg and slide it off the plastic frame. The interface
connector will slide off as the leg is removed.
2. 22 / Take-Apart rev. Aug 87 ImageWriter II