Owner`s manual

CARRIAGE ASSEMBLY
WITH RIBBON WIRE AND ASSEMBLY REMOVED
DRIVE BELT
`
1
FIGURE 11
2
1
1
FIGURE 12
Replace 1. Insert the flexible cable in the connector on the drive
PCB (Figure 12, #2). Push the connector in.
2. Replace the ribbon retainer and the screw that holds
down the retainer for the flexible cable
(Figure 12, #1).
3. Push the carriage assembly to the middle. Insert the
other end of the flexible cable in the connector (Figure
11, #1). Push the connector in.
4. Replace the ribbon wire and the ribbon assembly.
5. Perform the self-test.
ImageWriter II rev. Aug 87 Take-Apart / 2.19