Owner`s manual

4. Position the ribbon plate so that the front two tabs on
the side have the ridge of the color ribbon assembly
between them. Line up the tabs on the gear plate with
the top of the ribbon plate (Figure 10, #2), and push
the ribbon plate down. It will click into position.
WARNING: Verify that the two tabs are riding on the
ridge of the color ribbon assembly. If they are not, you
may get poor print quality or no printout at all.
5. Replace the two small plastic pieces with the catches
on them. Slide the piece for the left side (Figure 10,
#4) over the left side of the ribbon plate and carrier
assembly. Rotate the piece until the black catch pops
into the hole on the carrier assembly (Figure 10, #5).
Repeat this step for the other piece on the right side.
6. Replace the ribbon cartridge.
7. Replace the top cover.
8. Replace the paper cover.
9. Perform the self-test.
2.18 / Take-Apart rev. Aug 87 ImageWriter II