Owner`s manual

15. Put the ribbon plate aside.
16. Disconnect and remove the ribbon wire (Figure 9, #1).
1
FIGURE 9
Replace 1. Rewrap the ribbon wire as shown in Figure 9. Be sure
the wire crosses at the front of the gear. Verify that the
spring under the spindle gear is in position before you
continue.
SIDE VIEW
4
2
3
5
1
FIGURE 10
2. Gently position and push the ribbon-detect switch into
the top of the ribbon plate (Figure 10, #3).
3. Reinstall the wires under the retainers and the bracket
(Figure 10, #1).
ImageWriter II rev. Nov 88 Take-Apart / 2.17