Owner`s manual

6. Move the small catch to the top (Figure 7, #3). Gently
pull the plastic piece straight out.
7. Repeat for the right side. The catches are not
interchangeable.
8. Remove the color ribbon selector wires from the
plastic clamp (Figure 8, #1) by gently prying the clamp
away from the carrier assembly.
9. Using a jeweler's flathead screwdriver, push the tabs
toward the center of the ribbon plate
(Figure 8, #2).
10. Slowly lift the entire plate up. If the ribbon wire (Figure
7, #5) comes with it, repeat step 9. The gears are
located under the plate.
Not Available
FIGURE 8
11. Lay the ribbon plate upside down to remove the color
ribbon detect switch (Figure 8, #3). Do not remove the
switch unless replacing the ribbon plate.
12. Insert a jeweler's flathead screwdriver under the tab
on each side of the detect switch (Figure 8, #4).
13. Gently push the switch down with a third jeweler's
flathead screwdriver.
14. Remove the wires from the retainers on the front of the
ribbon plate.
2.16 / Take-Apart rev. Aug 87 ImageWriter II