Owner`s manual

21. Remove the bushing and gear (Figure 16, #1) from the
left side of the platen. Using a 1/16-inch or 2-mm pin
punch, carefully tap the split–sleeve pin (Figure 16, #2)
all the way through the platen shaft and pull it out. (This
pin will be reused, so do not damage it.)
CAUTION: T o avoid damage to the platen end shaft,
do not apply excessive force while removing the pin.
22. Remove the old mechanical paper–empty sensor frame
(Figure 16, #3).
23. Replace the split sleeve pin in the platen shaft (Figure
16, #2) and reinstall the gear and bushing (Figure 16,
#1).
24. Remove the three screws (Figure 17, #1) that hold the
paper guide in place.
FIGURE 17