Owner`s manual

10. Turn the printer up so that it rests on its front side and
the screws holding the right and left support legs face
you. Remove the two screws and the support legs by
pulling the legs toward you and then out. Slide the AC
socket out of the right leg and the pin socket from the
left leg. Bring the printer back down to its operating
position.
11. Release the connectors at locations CN3 and CN9
(Figure 1 1, #1 and #2) from the left side of the main
logic board. Release the gray ribbon connector
(Figure 1 1, #3).
FIGURE 1 1