Owner`s manual

2. Push the carrier shaft toward the rear of the machine.
Using needlenose pliers, install the shim on the left
side of the carrier bar by inserting the two protruding
tabs into the holes on the shim (Figure 4, #1). Slide the
shim into position. Release the carrier shaft.
3. V erify that the gap is now correct.
4. Replace the ribbon cartridge and the paper cover .
5. Perform the self-test.
Remove T o remove a shim:
1. Look at the left side of the carrier shaft. (Figure 4, #1).
• If there is a shim installed, remove it with needlenose
pliers.
• If there is no shim installed, be sure the cam washer
on the left side is positioned correctly .
2. V erify that the gap is now correct.
3. Replace the ribbon cartridge and the paper cover .
4. Perform the self-test.