Owner`s manual

• SHIMS
A shim is a small 3-sided metal piece with two holes on one
side (Figure 1). The shim is used to correct the distance
between the print head and the platen.
FIGURE 1
IMPORT ANT : Before performing this procedure, check
the cam washer on the left side of the carrier shaft to be
sure it is in position (Figure 2). The narrower part of the hole
in the cam should be in the top position when placing the
cam on the carrier shaft. Refer to Section 2, T ake-Apart,
"Carrier Block Assembly and Print Head PCB," for complete
instructions.
FIGURE 2