Specifications
Table Of Contents
- iMac (Early 2006 17-inch)
- Contents
- Take Apart
- General Information
- Access Door
- Memory
- Front Bezel
- Camera Board
- Lower EMI Shield
- IR Board
- AirPort Extreme Card
- Battery
- LCD Display
- LVDS Display Cable
- Inverter
- Speakers
- Bluetooth Card
- Optical Drive
- Hard Drive
- DC-DC Board
- Power Supply
- Logic Board
- CPU Fan
- Optical Drive Fan
- Hard Drive Fan
- AC Line Filter
- Ambient Light Sensor Board
- Clutch
- AirPort Antenna
- Bluetooth Antenna
- DC Power Cable
- Camera Cable
- Chassis
- Rear Housing
- Troubleshooting
- Views
iMac (Early 2006 17-inch) Take Apart — Display Panel-53
Replacing the LCD Display
Replace the LVDS cable on the rear of the display panel.
Connect the two inverter-to-display cable connectors and tape them to the back of the
display panel.
Replace the right panel mounting bracket on the display panel with two screws.
Replace the left bracket on the display panel with two screws.
Push aside any cables that could interfere with the display mounting brackets when lowered
into position.
Make sure the inverter cable extends beyond the bottom of the display panel, and install the
panel with the mounting bracket screw holes and the screw mounts aligned.
Secure the panel with four mounting screws.
Connect the inverter cable connector.
Connect the LVDS cable connector and secure it with two screws.
Fold the EMI tape rmly over the left, top, and right edges of the display panel. Use the black
stick to adhere the tape rmly and rub out wrinkles.
Replace the lower EMI shield.
Replace the front bezel.
Replace the access door.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.