Specifications
Table Of Contents
- iMac (Early 2006 17-inch)
- Contents
- Take Apart
- General Information
- Access Door
- Memory
- Front Bezel
- Camera Board
- Lower EMI Shield
- IR Board
- AirPort Extreme Card
- Battery
- LCD Display
- LVDS Display Cable
- Inverter
- Speakers
- Bluetooth Card
- Optical Drive
- Hard Drive
- DC-DC Board
- Power Supply
- Logic Board
- CPU Fan
- Optical Drive Fan
- Hard Drive Fan
- AC Line Filter
- Ambient Light Sensor Board
- Clutch
- AirPort Antenna
- Bluetooth Antenna
- DC Power Cable
- Camera Cable
- Chassis
- Rear Housing
- Troubleshooting
- Views
iMac (Early 2006 17-inch) Take Apart — Display Panel-52
Note: If replacing a bad LCD display, you will also need to remove the lower EMI shield
(if still attached), the display panel mounting brackets, and the LVDS cable as follows.
If attached, peel the lower EMI shield o the bottom edge of the display panel.
Using a torx T10 screwdriver, remove two screws from the left side panel mounting bracket.
Using a torx T10 screwdriver, push the tape aside and remove the two mounting screws from
the right side panel bracket as shown below.
Peel back the tape where shown below, and disconnect the two inverter-to-display cable
connectors.
Remove the LVDS cable from the rear of the display.
Return the panel to Apple. Note: The panel is a like-for-like exchange.
5.
6.
7.
8.
9.
10.