Specifications
Table Of Contents
- iMac (Early 2006 17-inch)
- Contents
- Take Apart
- General Information
- Access Door
- Memory
- Front Bezel
- Camera Board
- Lower EMI Shield
- IR Board
- AirPort Extreme Card
- Battery
- LCD Display
- LVDS Display Cable
- Inverter
- Speakers
- Bluetooth Card
- Optical Drive
- Hard Drive
- DC-DC Board
- Power Supply
- Logic Board
- CPU Fan
- Optical Drive Fan
- Hard Drive Fan
- AC Line Filter
- Ambient Light Sensor Board
- Clutch
- AirPort Antenna
- Bluetooth Antenna
- DC Power Cable
- Camera Cable
- Chassis
- Rear Housing
- Troubleshooting
- Views
iMac (Early 2006 17-inch) Take Apart — Front Bezel 31
Make sure the memory ejector levers are in the closed position (as shown) before lowering
the front bezel over the ejectors.
Continue to lower the font bezel down and press the top corners of the front bezel to
connect the latches. Note: Check that the latches are connected by lifting the front bezel at
each corner.
Replace the four bezel mounting screws along the bottom of the computer.
Replace the access door and tighten the two captive screws.
Install any removed DIMMS after the unit is fully assembled. Important: Memory DIMMs
must be installed by hand. Do not use the memory ejector levers to install memory.
4.
5.
6.
7.
8.