Specifications

2. Grab the logic board by the battery retainer and the hard drive connector. Lift the
board and pull back to release the board from the bottom housing and I/O ports. Note:
The I/O port covers may come out with the logic board when it’s removed.
3. Remove the I/O port covers from the logic board.
Warning: Whenever the bottom housing is opened for service, you must do two things:
1.You must clean the original thermal film from the surfaces joining the thermal
interface layer and reapply thermal paste to the thermal pipe.
2. You must tighten the four torx screws on the bottom housing to a minimum of
17
in.-lbs. If you do not have a torque driver, you will have to make sure these
screws are tightened by hand FIRMLY, BUT NOT FORCIBLY. Or, purchase the
service tool (076-0899) in order to ensure the thermal pipe is firmly
mated with the top base. If the bottom housing is not securely attached to the
base in this fashion, the CPU may overheat and become damaged.
Failure to
follow either of these steps could cause the computer to overheat and damage
internal components.
Refer to the topic, “Thermal Paste Application” for detailed information.
Warning: Whenever the logic board is separated from the bottom housing, you must
install new thermal pads to three surfaces on the bottom housing. The thermal pads help
cool components on the logic board. Failure to apply these pads whenever the logic board
26 iMac (Flat Panel) Take Apart
Logic Board