Installation manual

OWC Data Doubler Chapter 2 - Bracket Attachment
2.1 Drive Attachment
2 BRACKET ASSEMBLY
Take the SATA cable that came bundled with your OWC Data Doubler and
insert the large end of the SATA plug onto the hard drive that you are going
to install into the bracket. It will only t one direction, and it is keyed to
prevent improper installation. Once that is inserted, gently set the hard
drive into the OWC Data Doubler bracket with the SATA cable towards the
back of the OWC Data Doubler, as shown in the above picture.
➀
While holding the drive in the bracket, turn the OWC Data Doubler over so
that you can see the bottom. Insert the 4 included Phillips screws through
he bracket, into the bottom of the hard drive. Insert the rst screw a few
turns and then start the other screws before fully tightening all of them.
➁