User Guide

iMac (Early 2006 20-inch) Take Apart — Lower EMI Shield 44

Replacing the Lower EMI Shield

Position the lower EMI shield over the bottom of the unit so that the holes (for the IR board

and the LED) in the shield are properly aligned.

Press the sticky, edge of the EMI shield onto the bottom side of the display panel. The crease

in the EMI shield should align with the edge of the panel.

Fold down the EMI shield and press it rmly over the bottom edge of the rear housing. Use a

black stick to rub out any air bubbles and ensure that the EMI shield adheres rmly and

without wrinkles along all edges.

Make sure the memory eject levers are in the closed position as shown above.

Replace the front bezel.

Replace the access door.