User Guide

iMac (Early 2006 20-inch) Take Apart — Camera Board 41
Tuck the camera board cables neatly into the channel on the rear housing.
Position the memory ejector levers into the closed position.
Continue to lower the font bezel down over the pull rings (in the memory compartment)
and then lower the top corners of the front bezel so they connect with the magnetic latches.
Note: check that the latches are connected by lifting the front bezel at each corner.
Replace the bezel screws along the bottom of the computer.
Replace the access door; tighten the two captive screws
4.
5.
6.
7.
8.