User Guide

iMac (Early 2006 20-inch) Take Apart —AC Line Filter 103
Replacing the AC Line Filter
Install the AC power lter on the rear housing screw mounts with three self tapping screws.
Install the power inlet ground cable to the chassis with a machine screw.
Route the power inlet cable beneath the chassis as shown in the photo above, and connect
it to the power supply.
Using the EMI tape, securely tape the top and bottom edges of the AC power inlet to the
rear housing.
Replace the AC/DC power supply.
Replace the hard drive.
Replace the logic board.
Replace the speakers.
Replace the display panel.
Replace the IR Board.
Connect the antennas.
Replace the lower EMI shield.
Replace the front bezel.
Replace the memory access door.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.