Operating instructions

GeBE E + F GmbH • www.oem-printer.com • GeBE Doc. No.: SMAN-E-689-V1.1 • Thermal Printer GPT-4378-FLASH-70-iBT
11
Exchange batteries
9.2 Exchanging Batteries
1. The lid of the battery compartment on the bottom
of the printer can be easily opened by pressing a coin
against the spring latch.
2. Exchanging Battery Packs
The 7pin battery connector (9) is accessable through
the window in the bottom of the battery compartment.
By pulling at the connection cable of the battery pack
with force, connector (9) is unplugged from the
socket. The connector of the new battery pack can be
plugged in using taper-nose pliers (tweezers).
Please dispose batteries only in accordance with your
local environmental regulations, or send them on your
costs (DDP) back to us. Never throw batteries in the
garbage.
9.3 Cleaning
After larger print efforts, depending on the paper
quality and adverse environmental conditions, it may
be necessary to clean the print head, sensor, and the
platen roll, especially, if some areas are no longer
printed properly.
• Open paper supply lid and remove paper roll.
• Loosen dirt particles at the paper sensor and the
tear-off bar with a small brush.
• Blow forcefully into the paper supply compartment
in order to remove the coarse dust.
• Soak Q-tip in isopropanol (IPA) and clean the print
head, or use print head cleaning pin/cleaning card.
• Other stubborn debris can also be removed with a
Q-tip (IPA).
For operations with a clock, you have max.
one minute to exchange batteries before
the clock loses its setting.
9 Battery plug connection, 7pin
10 Battery compartment lid with spring catch
The GeBE-FLASH
®
for iOS is secured against
usual maloperations. An explosion risk due to
the insertion of a wrong battery type, a short
circuit, manipulations at the battery or
temperatures above 80°C can not be excluded.
Never use sharp objects for cleaning. This
might cause damage to the print head.
1.
2.
11 Paper tear-off bar
12 Print head
13 Paper sensor
Only order the battery type given in this manual.
Before inserting it, check for the correct part
number, to ensure you are using the correct type.
10
9
11
12
13