User Guide

50 - Power Mac G4 Cube Take Apart
Video Card
8. If the replacement card does not have a fence already installed, install the fence that
came in the box with the card. Using a Phillips screwdriver, install the two Phillips
screws on either side of the ADC connector and the two Torx screws on the fence side
tabs. Using pliers, install the two jack-nut screws on either side of the VGA connector.
9. Connect the replacement video card to the video riser card. Firmly press the card into
the connector until it snaps into place.
10. Tilt the video card into the chassis so the video ports align with the oval openings in
the chassis.
11. Position the gold connectors on the video riser card over the card connector, and
press the video riser card into place.
12. Install the three screws.
13. Reassemble and test the computer.
Warning: Never turn on the computer unless all of its internal and external
parts are in place and it is closed. Operating the computer when it is open or
missing parts can damage the computer or cause injury.