User Guide

Power Mac G4 Cube Take Apart - 19
Plastic Shell from Enclosure
5. Lift the plastic shell off of the grill.
6. Position the replacement plastic shell over the grill.
7. Before installing the liner in the shell, check that the power button is in place. If the
power button gasket assembly has slipped out of the socket, install it under the gray
cover sheet. Hold it in place as you slide the liner in the replacement shell.
8. Turn the grommets so that a corner of their flat edge locks the grill into place.
Hold each grommet in that position as you tighten the Torx screws.
9. Install the two Phillips screws.