Setup and Administration Guide
Table Of Contents
- Final Cut Server Setup and Administration Guide
- Contents
- Welcome to FinalCutServer Administration
- PartI: Installation andConfiguration
- Overview of FinalCutServer
- Using the Installer
- Configuring System Preferences
- Adding Users and Groups
- Using Device Setup Assistant
- Using Automation Setup Assistant
- Backing Up FinalCutServer
- Installing FinalCutServer Clients
- PartII: General Administration
- General Settings and Preferences
- Groups and Permissions
- Managing Metadata
- Managing Devices
- Managing Transcode Settings
- Managing Automations
- About Jobs and Logs
- Glossary
- Index
3
39
3 Configuring System Preferences
This chapter covers the following:
 Introduction to Final Cut Server System Preferences (p. 39)
 General Pane Settings (p. 40)
 Group Permissions Pane Settings (p. 42)
 Devices Pane Settings (p. 43)
 Automations Pane Settings (p. 44)
 Backup Pane Settings (p. 45)
Once you have installed Final Cut Server, you can continue its setup by configuring
Final Cut Server System Preferences.
Introduction to Final Cut Server System Preferences
After you have installed Final Cut Server, a Final Cut Server item is added to the Other
section of System Preferences. Clicking this item shows the General pane (or the last
pane that was selected) of Final Cut Server System Preferences.
Click the lock and
authenticate yourself to
make changes to any of
these panes.
Click the question mark
to view a PDF version of
this manual.
Click these buttons to
select the pane to
configure.