Setup and Administration Guide
Table Of Contents
- Final Cut Server Setup and Administration Guide
- Contents
- Welcome to FinalCutServer Administration
- PartI: Installation andConfiguration
- Overview of FinalCutServer
- Using the Installer
- Configuring System Preferences
- Adding Users and Groups
- Using Device Setup Assistant
- Using Automation Setup Assistant
- Backing Up FinalCutServer
- Installing FinalCutServer Clients
- PartII: General Administration
- General Settings and Preferences
- Groups and Permissions
- Managing Metadata
- Managing Devices
- Managing Transcode Settings
- Managing Automations
- About Jobs and Logs
- Glossary
- Index
Chapter 2 Using the Installer 25
I
8 In the Serial Number field, enter the Final Cut Server serial number printed on the
Software Serial Number label attached to the serial number sheet included in your
Final Cut Server box, then click Continue.
Following are some tips for entering your serial number correctly:
 Make sure you are copying the original serial number that is on the front of the serial
number sheet.
 Make sure you enter the software serial number, not the Support ID number.
 Make sure you enter a zero and not an O, a 1 and not a lowercase L, where appropriate.
 Include dashes in the serial number.
 Don’t enter spaces before or after the serial number.
 Verify that you have typed the serial number correctly.
Important: After three incorrect serial number entries, the installer quits. To begin the
installation process again, return to step 2.
The Customer Profile Selection pane appears.