Setup and Administration Guide

208 Part II General Administration
Destination Metadata Settings
These settings define the metadata applied to the copied asset:
 Job Priority: Choose the priority of the copy job from the pop-up menu.
 Copy Metadata: Select the “Run in parallel” checkbox to allow this response to run at
the same time as other copy responses in a watcher or subscription. When this is not
selected, the response runs serially, based on its order in the watcher or subscription.
Select the Overwrite checkbox to overwrite an existing destination file if it has the
same filename as the file being copied.
Note: Delete responses always run serially and after the copy responses.
 Create Asset: Select this to have the copied asset added to the Final Cut Server
catalog. Selecting this activates the Metadata Set and Production selection settings.
 Metadata Set: This is where you choose the metadata set to apply to any new assets
found by the scan. The settings below the Metadata Set pop-up menu allow you to
enter default descriptions, keywords, and so on to apply to the new assets.
 Production: Enter a name to create a new production that the assets are added to.
Alternatively, click Select to search for an existing production to add the assets to.
 Overwrite: Select this to have the copied asset replace an existing file if it has the
same filename.