Setup and Administration Guide

204 Part II General Administration
Scan Source Section
This is where you choose the device to scan and set the folder within that device to scan.
Metadata Set Section
This is where you choose the metadata set to apply to any new assets found by the
scan. The settings below the Metadata Set pop-up menu allow you to enter default
descriptions, keywords, and so on to apply to the new assets.
Note: By default, all scan production responses have version control set based on how
the Final Cut Server installer was configured. You can verify and change version control
for a scan production response by choosing the Versioning metadata group (in the
pop-up menu just below the Metadata Set pop-up menu) and selecting the Version
checkbox. See “Using the Final Cut Server Installer” on page 21 for more information
about the installer’s version control setting.
Production Metadata Section
This is where you choose the metadata set to apply to the production. The settings
below the Metadata Set pop-up menu allow you to enter default descriptions,
keywords, and so on to apply to the productions.