X

Chapter 10 Addtransitions,titles,eects,andgenerators 265
Onscreen control examples
Following are a few examples of the onscreen controls you might use while working
with clip eects and transitions. Many other clip eects and transitions use these same
or similar controls—the examples are intended to provide general information about
using the onscreen controls.
Keep the following in mind while going through these examples:
These examples assume you are familiar with applying clip eects to clips in Â
the Timeline.
You can apply multiple clip eects to the same clip, but for the purpose of these Â
examples, it’s best to either apply each clip eect to a dierent Timeline clip or
remove the clip eect before applying a dierent one.
These examples also assume you are familiar with adding transitions to edit points Â
in the Timeline.
Most of the eects and transitions have additional adjustments in the Video Â
inspector or Transition inspector.
Example: Use onscreen controls to apply a Censor eect
1 Open the Eects Browser and drag the Censor eect to a clip in the Timeline.
2 To adjust the eect’s onscreen controls, do either of the following:
 To position the eect: Drag the center circle.
 To set the eect’s size: Drag the outer circle.
Drag this center circle to
position the effect.
Drag this circle to
set the effect’s size.