X
Table Of Contents
- Final Cut Pro X Logic Effects Reference
- Contents
- An Introduction to Logic Effects for Final Cut Pro X
- Distortion Effects
- Echo Effects
- Delay Designer
- Getting to Know the Delay Designer Interface
- Getting to Know Delay Designer’s Main Display
- Using Delay Designer’s View Buttons
- Zooming and Navigating Delay Designer’s Tap Display
- Creating Taps in Delay Designer
- Selecting Taps in Delay Designer
- Moving and Deleting Taps in Delay Designer
- Using Delay Designer’s Tap Toggle Buttons
- Editing Parameters in Delay Designer’s Tap Display
- Aligning Delay Designer Tap Values
- Editing Filter Cutoff in Delay Designer’s Tap Display
- Editing Pan in Delay Designer’s Tap Display
- Editing Taps in Delay Designer’s Tap Parameter Bar
- Editing Delay Designer Taps with the Shortcut Menu
- Resetting Delay Designer Tap Values
- Using Delay Designer’s Master Section
- Working with Delay Designer in Surround
- Modulation Delay
- Stereo Delay
- Tape Delay
- Delay Designer
- Equalizers
- Levels Effects
- Modulation Effects
- Spaces Effects
- Space Designer Convolution Reverb
- Getting to Know the Space Designer Interface
- Working with Space Designer’s Impulse Response Parameters
- Working with Space Designer’s Envelope and EQ Parameters
- Working with Space Designer’s Filter
- Working with Space Designer’s Global Parameters
- Using Space Designer’s Input Slider
- Using Space Designer’s Latency Compensation Feature
- Using Space Designer’s Definition Parameter
- Using Space Designer’s Rev Vol Compensation
- Using Space Designer’s Output Sliders
- Working with Pre-Dly (Predelay) in Space Designer
- Using Space Designer’s IR Start Parameter
- Using Space Designer’s Spread Parameters
- Automating Space Designer
- Specialized Effects and Utilities
- Vocal Effects
Tremolo Effect
The Tremolo effect modulates the amplitude of the incoming signal, resulting in periodic
volume changes. You’ll recognize this effect from vintage guitar combo amps (where it
is sometimes incorrectly referred to as vibrato). The graphic display shows all parameters,
except Rate.
• Depth slider and field: Determines the modulation amount.
• Waveform display: Shows the resulting waveform.
• Rate knob and field: Sets the frequency of the LFO.
• Symmetry and Smoothing knobs and fields: Use these to alter the shape of the LFO
waveform.
If Symmetry is set to 50% and Smoothing to 0%, the LFO waveform has a rectangular
shape. This means that the timing of the highest and lowest volume signals is equal,
with the switch between both states occurring abruptly.
• Phase knob and field: Available only in stereo and surround instances. Controls the
phase relationship between the individual channel modulations. At 0, modulation
values are reached simultaneously for all channels. Values of 180 or −180 indicate the
greatest possible distance between the modulation phases of the channels.
• Distribution pop-up menu: Available only in surround instances. Defines how phase
offsets between individual channels are distributed in the surround field. You can
choose from “circular,” “left↔right,” “front↔rear,” “random,” and “new random”
distributions (to randomize the phase, choose “new random”).
• Offset slider and field (Extended Parameters area): Sets the amount that the modulation
(cycle) is shifted to the left or right, resulting in subtle or significant tremolo variations.
96 Chapter 5 Modulation Effects