7
Table Of Contents
- Final Cut Pro 7: Exploring Final Cut Pro
- Contents
- Chapter 1: A First Look at Final Cut Pro
- Chapter 2: Bringing Media into Your System
- Chapter 3: Preparing Clips in the Viewer
- Chapter 4: Working with the Canvas and Timeline
- Chapter 5: Basic Editing
- Chapter 6: Working with Audio
- Chapter 7: Creating Voiceovers
- Chapter 8: Adding Video Filters and Transitions
- Chapter 9: Outputting Your Finished Movie
- Chapter 10: Getting Answers
96
Chapter 4 Working with the Canvas and Timeline
Place a clip so that it ends at a specic point in a sequence:
Place the playhead on a frame in the sequence where you would like the incoming clip 1
to end.
Press O to set an Out point for the sequence in the Timeline. 2
Sequence Out point
marking where an
incoming clip should end
In the Viewer, set In and Out points in a clip. 3
Drag the clip from the Viewer to the Overwrite section of the Canvas Edit Overlay. 4
Final Cut Pro places the Out point of the incoming clip at the sequence Out point.
Fill a specic segment of a sequence with a clip:
Place the playhead on a frame in the sequence where you would like an incoming clip 1
to start.
Press I to set an In point in the sequence. 2
Move the playhead ahead to a frame where you would like the clip to end. (For now, 3
just move the playhead ahead about 10 frames.)
Press O to set an Out point in the sequence. 4