User Guide

Chapter 1 Working With HDV 19
Preview Area
This section of the Log and Capture window lets you view video from tape while you
log and capture it. The video preview area remains black until your camcorder or deck
is turned on and a tape is playing in the device. The following controls appear if your
camcorder or deck is on and properly connected, and device control is enabled.
Important: If your computer has a PCI graphics card installed and you are logging or
capturing HDV footage, Final Cut Pro does not preview video or audio in the Log and
Capture window. You can still log and capture, but you need to use your HDV camcorder
display to preview video.
Video Preview Area
 Available space and time: Final Cut Pro displays the amount of available space on all
currently assigned scratch disks.
 Device status: Shows the readiness of camcorders and decks connected to your
computer and being controlled by Final Cut Pro. If you see “VTR OK,” your equipment
is connected and working properly.
 Timecode Duration field: Displays the duration, in timecode, between the current
tape In and Out points. If you enter a duration in this field, the Out point is adjusted.
 Current Timecode field: Displays the timecode number of the current frame of your
source tape. You can enter a timecode number in this field to navigate to that
timecode point on your tape.
∏ Tip: When using the Log and Capture window with a native HDV Easy Setup, you can
drag timecode values between the Log and Capture timecode fields by holding down
the Option key while you drag a timecode value from one field to another. Dragging
timecode from other windows is not supported.
Clip In Point
Timecode field
Current Timecode
field
Clip Out Point
Timecode field
Timecode Duration field
Video preview area
Device
status
Shuttle control
Available space
and time
Transport
controls