User`s guide

Sound Test:3
AA= 0C DD= 01: RAM data error
02: RAM address error
03: Data register failed
04: Control register failed
05: Oscillator interrupt timeout
Note: If a ZipGS accelerator card is installed and not disabled,
then, depending upon DIP Switch settings, your GS may fail parts
of this test-- such as the Oscillator interrupt timeout check.
Such a failure does not necessarily indicate a hardware fault.
Other
AA= FF (test number= $FF) According to M. Fischer this shows a likely
problem with the Mega II chip because that test number is used only
during manufacturing testing.
______________________________
From: Paul Creager
003- What does RamFAST Fatal Memory Fault Error ___ mean?
$00 Unknown, probably means that the RamFAST is very confused
$01-08 DRAM memory test failure
$09 EPROM checksum failure
$0C Z180 processor crashed, indicates some hardware fault
$0D Error writing cache data to disk
$0E Termination power error
______________________________
004- What is the explanation for getting a ___ error?
0027 (ProDOS Error $27, ...)
0047 (ProDOS Error $47, ...)
0048 or 0049 (e.g. ProDOS Error $48, ...)
004B (ProDOS Error $4B, ...)
0051 (ProDOS Error $51, ...)
005A (ProDOS Error $5A ...)
0088 "network error"
0201 "could not allocate memory" error
0400 (see 0911)
0512 (FATAL SYSTEM ERROR 0512) "badNdaTitleString"
0681 and 0682 "bad event que" and "bad que handler"
0682 "bad que handler"
08FF "UNCLAIMED SOUND INTERRUPT"
0911 and 09010001 (FATAL SYSTEM ERROR 0911)
0C000003 GS Diagnostic Self-Test error
1102 "OMF version error"
1104 "file is not a load file"
1301 "Unknown error $1301"
IIe Self-Test RAM error display
RamFAST-SCSI FATAL MEMORY FAULT CODE=08
RamFAST MLI Error!