User`s guide

SW-2 #4: If you have the 32K Memory Option, LocalTalk card, etc. installed, SW-2
#4 should be set DOWN. Otherwise, it should be set UP (the usual setting).
IW-II: SW-2 #5-#6 on the IW-II are factory-set to optimize hammer firing and
should be left alone by the use (On my IW-II #5 is DOWN and #6 is UP.)
'LQ: SW-2 #5-#7 (#7 is only on the 'LQ) on the IW-II LQ are used to set the
number of cut sheet feeder bins attached to the printer.
'LQ SW-2 #5 #6 #7
1 U U D
1 and 2 D U D
1, 2, and 3 D D D
1 and envelope U U U default
1, 2, and envelope D U U
1, 2, 3, and envelope D D U
'LQ: SW-2 #8 (only on the 'LQ) sets Auto Paper Load position.
To print line U default
To paper bail D
'LQ: SW-3 #1-#5 (only on the 'LQ) are factory-set to optimize printer operation
and should be left alone by the user.
'LQ: SW-3 #6-#8 (only on the 'LQ) control vertical alignment of dots in
bidirectional printing mode. Set for best alignment.
______________________________
003- How do I do the ImageWriter II LQ alignment test?
The 'LQ Alignment Test
With printer OFF, press Select, Line Feed, Form Feed. Hold them pressed,
turn ON printer, and release buttons after printer head starts to move.
The printout shows four possible switch settings with six lines of vertical
bar printouts for each setting.
Settings are indicated like this: 1 0 0 (which means DOWN UP UP). An
asterisk by a setting means it is the current setting.
Set the switches to the setting which best lines up the vertical bars in
the printout.
______________________________
004- Will a 'straight-through' cable work for connecting
an ImageWriter II to my GS?