User`s guide

German U U D
Swedish D U D
French U D D
Spanish D D D
Form Length
SW-1 #4
11 inches U default
12 inches D
Auto Perforation Skip
SW-1 #5
No U default
Yes D
Character Pitch
SW-1 #6 #7
10 cpi U U
12 cpi D U default
17 cpi U D
160 dpi D D (proportional)
Line Feed with Carriage Return
SW-1 #8
No U CR only
Yes D CR plus LF
The settings for SW-2 are concerned with hardware interfacing. #1 and #2
set the baud rate the printer will expect:
SW-2 #1 #2
300 (on IW-II) U U
19200 (on IW-II LQ) U U 'LQ default
1200 D U
2400 U D
9600 D D IW-II default
You should set the switches to match the speed of your printer interface. For
the IIgs serial Printer Port, the Port and the DIP switches would normally be
set for the maximum speed the printer can handle (e.g. IIgs Port at 9600 baud
and DIP switches set DOWN DOWN for the IW-II).
SW-2 #3 is usually set UP to enable DTR hardware handshaking. If your interface
wants to use XON/XOFF handshaking, set #3 DOWN.