User`s guide

Unsolder the resistor, scrape the leads with a Stanley knife (gently!).
Clean the solder pads with some 200 grit wet and dry sandpaper. Resolder the
resistor and voila!
If the resistor is OK. Then check the "kickstart" cap in the power supply
(by swapping in a substitute). You can also check the STKxxxx power supply chip
for bad solder joints.
Good luck!
______________________________
From: Rubywand
038- When I play old hires games on my GS the RGB monitor
display does not look as good as my old Amdek Color-1
connected to the II+. What's wrong?
Most hires displays look better on a composite color monitor, such as the
Amdek Color-1, than they do on the GS's RGB monitor. The difference is even more
striking for double-hires displays. (King's Quest and Air Heart look much better
on a Color-1 connected to a IIc+ than on an RGB monitor connected to the GS.)
What's wrong is that the GS's display circuits do just a passable job of
translating hires and double-hires into RGB form.