User`s guide

______________________________
From: Alberto Roffe
006- Can someone tell me the dip-switch settings for the
"BITMOUSE" card by Sequential Systems?
The following comes from the BitMouse card manual, which I have installed in my
//e:
Switch 1- This switch controls mouse tracking sensitivity
OFF: Slow
ON: Fast
Switch 4- CPU speed
OFF: 1 to 4 MHz
ON: 5+ MHz
Switches 2&3 currently have no function.
______________________________
From: David E A Wilson
007- How can I switch my IIe keyboard layout to Dvorak?
There are a number of ways to set the NTSC //e keyboard to Dvorak.
1- If you have a Rev A motherboard cut X1 and join X2. This will allow AN2 to
control the keyboard layout (default will be Dvorak).
2- If you have a Rev B motherboard and want AN2 to control the keyboard layout
cut X2 and solder a short wire between the back half of X2 and the back half of
X3 (do not join X3).
3- Obtain a 24 pin IC socket. Solder 3 fine wires to pins 12, 19 and 24. Solder
the other ends to a SPDT switch (pin 19 to the centre/common terminal). Remove
the keyboard ROM, insert the switch+socket and then insert the keyboard ROM. Cut
X1 (if Rev A) or X2 (if Rev B) to isolate pin 19. Mount the switch somewhere
convenient.
All the above was taken from "Understanding the Apple IIe" by Jim Sather. I
recommend it to you.
______________________________
From: Bradley P. Von Haden, Supertimer, Chippy
008- My stock GS keyboard has been acting flaky; now I'm
looking for a GS keyboard replacement. What's available?
Work with an Apple IIgs: