User`s guide

______________________________
From: Sandy
025- How can I tell the firmware version of my TWGS?
With the IIGS turned on, press CONTROL-Apple-ESCAPE And go to the Transwarp
CDA The ROM version will be displayed on the screen.
______________________________
From: Mitch Spector
026- Do I need I need the 2B GAL for my Transwarp-GS to
use a SCSI interface? If I do, where can I get one?
The TWGS-2B GAL was a DMA fix Applied Engineering issued for the board. It
is an absolute requirement for Transwarp to work at all with at least some
RamFAST SCSI boards (e.g. the revision C boards).
With Applied Engineering long since out of business and the GAL virtually
impossible to duplicate by convential means, that leaves no good source for
replacement GALs. I found it much more affordable (and less hassle) to just
purchase a used TransWarp GS board with the 2B GAL to replace your old one.
______________________________
From: Supertimer
RamFAST revision D does not require the 2B GAL. The Apple High Speed SCSI
card works with all TransWarps GS units.
______________________________
From: Rubywand
027- When I change my ZipGS's Speed, Misc, and Slot
settings via the Zip CDA, they are always lost after
turning OFF the GS. What's wrong? Do I need a new BatRAM
battery?
No. The reason the settings are forgotten is that they are not saved in
BatRAM or on-disk. ZipGS settings made via the Zip CDA or via the Zip Control
Panel are only in effect for the current session of computing.
______________________________
028- What do the check-marks mean next to settings in the
ZipGS CDA? Are they original factory settings or what?
More like "or what". The check-marks indicate the settings of the DIP
switches on your ZipGS board.