Specifications

Chassis Plans CPX1-241 Technical Reference Appendix A – Display Serial Control Programming
Page 42
Function Command Description Acknowledge (if enabled)
Select RS-232
acknowledge
0xc1, “0” | “1” | “2” |
“3”
Disable/enable command
acknowledge.
“0” – acknowledge disabled.
“1” – acknowledge enabled.
“2” – serial command disabled.
“3” – serial command enabled.
Auto-setup 0xc3 Start auto-setup of current
vmode.
“0” – fail.
“1” – successful.
Command
availability
0xc4, n Check whether a command is
available.
“0” – not available.
“1” – available.
Auto-calibration 0xc5 Start auto-calibration of gain of
the RGB amplifier.
“0” – fail.
“1” – successful.
Freeze frame 0xc6, “0” | “1” Unfreeze / freeze frame “0” – unfreeze.
“1” – freeze.
Soft Power On/Off 0xc8,
“0” | “1” |
“?”
Soft power
off/on
query
“0” – Turn off the LCD power
and
backlight. Turn off memory
controller, Power down DVI
Power down ADC, Power
down Fclk PLL
“1” – Turn on the unit
Query video input
status
0xc9 Query the status of the primary
& pip status
“nn,nn” = input status
“nn,xx” digit = primary status:
“0”,”0” : invalid
“A”,”1” ARGB
“B”,”1” Composite
“B”,”2” Composite 2
“C”,”1” S-video
“C”,”2” S-video 2
“D”,”1” Component
“D”,”2” Component 2
“E”,”1” HDSDI
“E”,”2” HDSDI 2
“F”,”1” DVI
“H” “1” HDMI
“xx,nn”= PIP input status:
“0”,”0”: invalid
“A”,”1” ARGB
“B”,”1” Composite
“B”,”2” Composite 2
“C”,”1” S-video
“C”,”2” S-video 2
“D”,”1” Component
“D”,”2” Component 2
“E”,”1” HDSDI
“E”,”2” HDSDI 2
“F”,”1” DVI
“H” “1” HDMI
Video de-interlace
method
0xca,
“0” | “1”
“r” | “R”
“?”
De-interlace mode
Reset
Query
“3” ”1”- enable AFM
“3” ”0”- disable AFM
“4” ”1”- enable TNR
“4” ”0”- disable TNR
“5” ”1”- enable MADI
“5” ”0”- disable MADI
“7” ”1”- enable DCDi
“7” ”0”- disable DCDi